Photoshopchop.com

Photoshopchop.com (http://www.photoshopchop.com/forum/index.php)
-   3D RENDERING (http://www.photoshopchop.com/forum/forumdisplay.php?f=34)
-   -   Rim Tut Question (http://www.photoshopchop.com/forum/showthread.php?t=12269)

hawk_196 03-06-2005 01:08 PM

Rim Tut Question
 
I am willing to make a tutorial on how to draw and create rims. My questionf ro you guys is which program should I do it in? I could use either Inventor, Solidworks, or ACAD + either SW or Inventor to make the wheel, so which one should I use in my tutorial?

Keep in mind Inventor and Solidworks are very similar so if I do the tut in Inventor, you should be able to follow it fairly easily if you have a bit of knowledge in either program.

nasTone 03-06-2005 01:20 PM

I would do it in Solidworks personally. I think it is easier to use than Inventor, even though they are very similar programs. Don't bother doing a tutorial using AutoCAD and a 3D program. You would just be adding more places to get confused or lost to someone who does not have drafting knowledge.


All times are GMT -4. The time now is 08:21 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All rights reserved 2002-2008 Photoshopchop.com