Photoshopchop.com - View Single Post - Engine (was supposed to be 4A-GE)

t0tal · 04-11-2010, 02:15 PM

Thanks, they should look even better after I get them rendered. SolidWorks which I use to make these is mainly for 3D designing, not so much for the artistic side of things, so it takes a bit effort to "make them look good"..

I'm studying mechanical engineering at a technical university. This is a final assignment on a CAD course. Well, this is what I chose as my final assignment :P

04-11-2010, 02:15 PM	#3
t0tal PSC 1000 POSTS MEMBER Join Date: Apr 2004 Location: Tampere/Finland Posts: 1,731	Thanks, they should look even better after I get them rendered. SolidWorks which I use to make these is mainly for 3D designing, not so much for the artistic side of things, so it takes a bit effort to "make them look good".. I'm studying mechanical engineering at a technical university. This is a final assignment on a CAD course. Well, this is what I chose as my final assignment :P __________________