Thanx 4 all the coments, 1st I made the CF bodyparts so wide as I was trying to make it quite a lot wider than the normal body or even what normal wide arches would have made it, I wanted to achieve a "LeMans" tipe look, like its in a similar category than Veyron, CCX etc. So the arches are meant to make the car much, much wider and flatter. For those of you not liking the extra wide look, I actualy have a pic of the car as a standard model before i added any of the CF parts. I must just finish it off a bit then I'll post it for those interested to see what it looks like. As 4 the CF, I'm still trying to find the best way to add CF without making it look same all over the car. Curently i cut a diferent piece for each diferent angle of the body under it and for the round parts i'm trying to warp it to get the same round shape but I havent quite gotten the way just yet, if anyone have some advice for making perfect looking CF please help. Then finaly, the glowing LEDs, Im not sure what it is bout the glowing effect that I like but since I've only had negative feedback on it I will not use it again. I have to say that apart from personaly liking it I also used it to hide a bit of lazyness as I noticed it was easy to hide small flaws in my design behind that glow