This item has been shown 14 times.
Package Included:1*CA-288 board
he brightness is not enough, the screen is significantly darker than the originals .
now you need to do the two things :
First, attempt to use the remote control after connected to the transfer barefoot
to try brightness, if not resolved,test the actual pin voltage (Note: it will be the
greatest brightness in 0V, the brightness will be the darkest in greatest Voltage) .
if it is an analog voltage mode voltage range is between 0V-5V or 0V-3.3V,
if the voltage has been in hight condition all the time andcan not be reduced ,
now you need to adjust it . the voltage is 3.3V if it is PWM signal ,
it still can be up to request if adjust to
the greatest brightness at this time ,you need to do second program
Second, adjusting the resistance , increases the current to meet the requirements.